Building Your Own 6 x 9 Speaker Box

Speaker boxes are used to hold several component subwoofers and other speakers in an enclosure. Whilst most subwoofers are offered individually, you could want to put them into one box or enclosure by using a speaker box. 6 x 9 speaker boxes are not challenging to build but performed effectively, they can help improve the output of a stereo supply. For people who are not the best in the world with craftwork, they can just buy the subwoofers pre-enclosed.

What is Needed To Build A 6 x 9 Speaker Box?

It all depends on your price range and intent of the speaker boxes. You have to decide the size and the products used. The best material that you can use is a ¾-inch medium density filter board. If you have the money to spare, you can opt for products that are more exotic. But most people use fiberboard.

Aside from the fiberboard, you will also want a jigsaw (a bladed cutting power device), a power drill, a spiral but, a ¾-inch bit, a router, sandpaper, spray glue, solder gun and ammo, and some carpet if you want to cover the speaker box.

Most subwoofers on the industry come with a set of optional guidelines that let you design an enclosure for it. You don’t want to figure out the dimensions when a set of measurements have currently been integrated into the bundle. In this case, it indicates that you will not have to go via trial and error designing an enclosure because it has the widespread specs for most speaker boxes.

One crucial thing you have to recognize is that if the measurements are provided on an interior measurement, you could have to change the measurements by as much as ¾-inch.

It is also best to trace your preferred design and size measurements on the filter board rather than performing any freehand cutting. Prevent making use of markers for they can be ugly if the speaker boxes are not covered with carpet.

For apparent good reasons, you have to use your jigsaw to cut the design and not a knife or other cutting device. The jigsaw lets you cut clean and neat. The moment the pieces have been cut out, it is a fantastic strategy to make a trace of wherever the speakers would go into. For you to be able to do this you would have to use a router. The moment you have used the router to cut the holes, you would have to use sand paper to smooth out the holes made.

speaker box
Example of a speaker box

You should really also try to make holes so that the essential cables can pass through them. If the template or guidelines do not have any notes for holes, it is best to produce 2-inch holes on either side of the speaker box. Generally, sand them via so that there are no snags when performed.

Just after the holes have been cut, you can now assemble the boards with each other. Using screws, nuts, and washers, you have to make sure that they match tight and never rattle. Generally depart the front of the box last so that any last minute works can be dealt with.

The 6 x 9 speaker box is the best since all you have to do is pack the subwoofers in, close the front panel, and plug the power and connectors.

The real workload is in the development of the speaker box. You have to make sure that the work performed is up to precise and actual.

Shares